Phone App & Wiring Guide
Overview:
This is a manual used by Light Commercial Tech Support. See below to download.
Communication Wire Information
Note:
If you have a Symbio Condenser paired with a Symbio Air Handler with Model Number Digit 15 =
D (2 Stage Airflow/Single Zone VAV) you must run BOTH Adapter Board J15-3 & 4 to Relay Board J4-3
& 4 and Adapter Board J16-1 & 2 to Relay Board J7-1 & 2 shielded twisted pair!
Use the correct communication wire to ensure reliable communication between the Condenser and the
Air Handler.
Recommended wire Part Number is below.
Other wire may be used if it conforms to the following physical characteristics:
• Twisted pair (2-conductor) plus shield.
• Characteristic Impedance: 100 and 130 ohms.
• Distributed capacitance between conductors: < 100 pF/m.
• Distributed capacitance between conductor and shield: < 200 pF/m.
• Foil or braided shield is acceptable.
• Wire diameter: 22 to 18 AWG.
WARNING:
Information in this article is intended for use by individuals possessing adequate backgrounds of electrical and mechanical experience and who comply with all federal, state, and local laws, rules, orders, or regulations related to the installation, service, or repair of a heating or central air conditioning product. Any attempt to install, service, or repair a heating or central air conditioning product may result in personal injury and/or property damage. The manufacturer or seller cannot be responsible for the interpretation of the information contained herein, nor can it assume any liability in connection with its use.