Symbio 700 using Trane Tracer TU to edit or configure
Summary:
By following these steps, you can effectively configure the Symbio 700 using Trane® Tracer TU. You can follow the steps below.
1. From the Unit Summary page screen click on the right tab Equipment Utility:
2. From the equipment utility page click on the top Configuration tab
3. On the Configuration screen click the Edit button
4. A Stopping the Equipment dialog box will appear click the yes button to continue
5. When the unit has been configured you can edit each section and when the Symbio™ 700 has been replaced you need to fill in each section
WARNING:
Information in this article is intended for use by individuals possessing adequate backgrounds of electrical and mechanical experience and who comply with all federal, state, and local laws, rules, orders, or regulations related to the installation, service, or repair of a heating or central air conditioning product. Any attempt to install, service, or repair a heating or central air conditioning product may result in personal injury and/or property damage. The manufacturer or seller cannot be responsible for the interpretation of the information contained herein, nor can it assume any liability in connection with its use.