*LCU What Zone Sensor can I use with a Voyager unit that has a UCP main board?
Answer:
Generally a Voyager unit with a UCP main control board can use the same zone sensors that are currently available for Reliatel Units.
The following zone sensors will work on UCP:
BAYSENS106
BAYSENS107 (Heat Pumps)
BAYSENS108
BAYSENS109 (Heat Pumps)
BAYSENS110
BAYSENS119 - Note: Check the manufacture date of the UCP board installed in the unit. You may have to change the BAYSENS119 baud rate.
This is Option 17 in the BAYSENS119 setup menu.
Option 17 Baud Rate
0 = 1024 baud (UCP boards manufactured before January 1, 1996)
1 = 1200 baud (UCP boards manufactured after January 1, 1996)
If this board was in the unit you would set Option 17 to 0 = 1024 baud
BAYSENS135 - see below for wiring to a UCP unit with a 20 terminal LTB Board
.
WARNING:
Information in this article is intended for use by individuals possessing adequate backgrounds of electrical and mechanical experience and who comply with all federal, state, and local laws, rules, orders, or regulations related to the installation, service, or repair of a heating or central air conditioning product. Any attempt to install, service, or repair a heating or central air conditioning product may result in personal injury and/or property damage. The manufacturer or seller cannot be responsible for the interpretation of the information contained herein, nor can it assume any liability in connection with its use.