- *LCU UC400 BACnet MS/TP Controller preprogrammed for RTU or Heat Pump
- UC400 Controller preprogrammed for RTU or Heat Pump
- UC400 RTU or Heat Pump Heat Pumps 2H2C 2 heat 2 cool
The UC400 2H/2C and Bypass Damper controller templates were added in Tracer TU 9.4 V or higher and can be found at: My Documents/Tracer TU/ Tracer Concierge.
Tracer TU V10.4 or higher can be found at C:\Program Files (x86)\Trane\Tracer TU\Program\Configurations\Tracer Concierge
These can be loaded on a UC210 or UC400 using Tracer TU File Transfer Utility.
This new part (order number: UC400ABA0100011) is specifically set up for contractor install, typically for national accounts. The code is pre-loaded otherwise it is the same as the UC400. See the UC400 product page for sequence of operation and backup which can be loaded on a UC using the Tracer TU file transfer utility.
WARNING:
Information in this article is intended for use by individuals possessing adequate backgrounds of electrical and mechanical experience and who comply with all federal, state, and local laws, rules, orders, or regulations related to the installation, service, or repair of a heating or central air conditioning product. Any attempt to install, service, or repair a heating or central air conditioning product may result in personal injury and/or property damage. The manufacturer or seller cannot be responsible for the interpretation of the information contained herein, nor can it assume any liability in connection with its use.