VAV Default setpoints and CCP

Issue:

VAV Default setpoints and CCP

Resolution:

The CCP will update any changed value of the default setpoints. Rover can edit these but they will not remain unless you edit them with the VariTrac system. Rover Comm4 can be used initially to configure the boxes but not after the CCP is on the link. The CCP is the edit terminal after initial installation and commissioning.

Notes:

This applies to CCP II and III and likely the old Comfort Manager

Changes:

 

Other Question/Problem/Cause Statements:

• Can the CCP override the VAV default setpoints?

•  

  If I edit the default setpoints of a VAV box on a VariTrac system with Rover they return to the previous setting. Why does this happen?

• Default VAV setpoints in CCP

Facts:

• VARITRAC II CENTRAL CONTROL PANEL (CCP)
• VAV nonLonTalk
• VariTrac Comfort Manager
• VariTrac II Central Control Panel (CCP)
• VariTrac III Central Control Panel (CCP)
• Varitrac Software

Original wave: wave53449