Is it possible to associate the name of a VAV zone and its address in a CCP

Issue:

Is it possible to associate the name of a VAV zone and its address in a CCP

Resolution:

When the system first discovers devices the zones are given default names that include the address of the specific ucm.  These zone numbers will not be the same as the addresses shown in Rover but are the Rover address -64.  (Rover addresses start at 65, the CCP at 1).  After the names have been edited it may no longer be possible to determine which VAV zone name is associated with which dip switch address fromthe CCP III operator display.  With the CCP PC software it is still possible becouse both the name and the zone number are recorded. 

 

Other Question/Problem/Cause Statements:

• Is it possible to associate the name of a VAV zone and its address in a CCP

Facts:

• VARITRAC III CENTRAL CONTROL PANEL (CCP)
• VariTrac III Central Control Panel (CCP)

Original wave: wave3090