Issue:
Where should the static and temp sensor installed on a bypass system?
Resolution:
The distance between the bypass dampers and the static and the temp sensor should be the 2-3 times equivalent duct diameters.Â
The location is always on the up side of the bypass damper.
The communicating sensor bypass assembly is always on the discharge of the unit before the bypass valve.
Â
Other Question/Problem/Cause Statements:
- Where should the static and temp sensor installed on a bypass system?
- Where should I install the communicating sensor bypass assembly on the duct?
Facts:
- VARITRAC III CENTRAL CONTROL PANEL (CCP)
- VariTrac II Central Control Panel (CCP)
- VariTrac III Central Control Panel (CCP)
Original wave: wave6973
Document Identifier: DOC-80906
Document Identifier: 80906