Tracker stuck in auto-configuration

Issue:

Tracker stuck in auto-configuration

Resolution:

Give it 20 minutes
Then try cycling the power again, and give it another 20 minutes
Return to factory default
Check resistance - 22 AWG, 105 ohms, 50 to 95 ohms
Disconnect the comm link, cycle power, 20 minutes
Connect with Tracker software and check the software version

If you get the Software Not Available message, replace the main board.

If lontalk device is applicationless and reset to factory defaults does not resolve the problem, use Rover to check the link for any devices that may be in an applicationless state, unused DSNs, or duplicate addresses. 

Notes:

 

Changes:

 

Other Question/Problem/Cause Statements:

• Tracker stuck in auto-configuration
• reboot, stuck in active configuration, what should I do?
• upgraded the tracker, stuck in automatic configuration
• software not available

Facts:

• TRACKER BMTK
• Tracker BMTK

Original wave: wave4435