Issue:
How to change the descriptor state for a binary output on a TCM in an EMTK Tracker?
Resolution:
Reference Tracker Operators Guide ( EMTK-OG-8, page 78):
Open Contact means:
Enter + for ON or - for OFF to describe the state of the binary (relay) output when the normally open contact is open. For example, if Binary Output #1 is edited to OPEN CONTACT MEANS - OFF the relay is de-energized in the Unoccupied mode.
Â
Other Question/Problem/Cause Statements:
- How to change the descriptor state for a binary output on a TCM in an EMTK Tracker?
Facts:
- Thermostat Control Module (TCM)
- Tracker EMTK
Original wave: wave26437
Document Identifier: DOC-93047
Document Identifier: 93047