Medium Foundation - Error code P3 - Indoor Fan Overload Protection

Updated August 02, 2024 13:57

Error code P3

Summary:

Indoor Fan Overload Protection

Possible Cause:

EEV/filter drier/indoor coil blocked
Overload protector of indoor fan fault

Troubleshooting:

If there is a blockage - correct it
If the overload protector failed - replace the indoor fan

Articles in this section

Foundation - Medium - Error Code E8 - Discharge Temperature sensor fault for system B (T5-B)
Foundation - Medium - Error Code E9 - Return air cabinet mixed air temperature sensor fault (T1)
Foundation - Medium - Error Code EA - Outdoor ambient temperature sensor fault (T4)
Foundation - Medium - How to set the SW1 dip Switches on the Main Board
Foundation - Medium - How to view the Main Board mode descriptions and error history log.
Foundation - Medium - How to wire the field installed smoke detector on a Legacy 2020-2023 unit.
Foundation - Medium- Error Code E5 - Evaporator coil temperature sensor fault for Circuit A (T2-A / plug CN40)
Foundation - Medium- Error Code E6 - Evaporator coil temperature sensor fault for Circuit B (T2-B / plug CN41)
Foundation - Medium- Error Code Eb - Thermostat output signal sequence fault
Foundation - Medium- How to wire a smoke detector or safety device to a 7.5 ton - 12.5 ton DOE 2023-2024 main board.

See more