Skip to main content

| Trane Commercial HVAC Help Center

Sign in

Sign in

Trane Commercial HVAC Help Center
Terminal Products
Terminal Products
BCXE

Mixing Box - Actuator wiring detail and mixing box section

March 18, 2024 13:48 Updated

See attachments for further details and instructions.

Details:

The actuator is the same for LH and RH actuator access.
LH/ RH is determined by facing the discharge or (supply air blowing into your face). The actuator linkage will be longer on that side.

NOTE: It can be changed in the field by loosening the clamps and sliding the shaft to the other side.

Actuator part number = Trane ACT00338 or Engineering X13611055030

X13611005_G_watermarked.pdf
100 KB Download
Actuator detail - BCXE.docx
200 KB Download

Was this article helpful?

2 out of 5 found this helpful

Articles in this section

Corner Weights for BCXE
Coil header Penetration cover - GASKET
BCVE water leak
Field Supplied 0-10 VDC valve actuator wiring with UC400/ Symbio Controller
Wiring factory valve actuator
Wrong Disconnects
BCVE - Mounting Legs
Mixing Box - Actuator wiring detail and mixing box section
BCXE Schematics
Coil removal

Related articles

BCXE Schematics
BCVE - Mounting Legs
Wrong Disconnects
Mixing Box actuator set-up Example
IntelliPak 1 - Replacing Modulating Gas Heat Honeywell actuator with Belimo (Trane) actuator

Terms of Use | Privacy Policy
All trademarks referenced are the trademarks of their respective owners.
© 2023 Trane. All Rights Reserved.