Issue:
Is there anyway to bring the old starts and hours data into the new Dynaview?
Resolution:
With KestrelView version TV14.0 SP16 and higher, there is a way to copy old compressor starts and hours data to a new Dynaview. This function is not available from front panel. This function requires KestrelView to be changed to Access Level 4 to allow the information to be added to the new Dynaview.
This is applicable to all CH530 control based chillers:
- RTAC View – Setpoint View – Compressor Tab
- CGAM View – Unit View – Start & Hours Tab
- RTWD View – Unit View – Start & hours Tab
- RTUD View – Unit View – Start & hours Tab
- RTHD View – Setpoint View - Compressor Tab
TechTV:
Facts:
- Air-Cooled Chiller (Pueblo)
- Water-Cooled Chiller (Pueblo)
Document Identifier: DOC-80879
WARNING:
Information in this article is intended for use by individuals possessing adequate backgrounds of electrical and mechanical experience and who comply with all federal, state, and local laws, rules, orders, or regulations related to the installation, service, or repair of a heating or central air conditioning product. Any attempt to install, service, or repair a heating or central air conditioning product may result in personal injury and/or property damage. The manufacturer or seller cannot be responsible for the interpretation of the information contained herein, nor can it assume any liability in connection with its use.